Force measuring spring X-119 Static load measurement at the lift cabin

• Area: 4kN-40kN 
• Size: 160x80x40 mm 
• Notes: High accuracy and repeatability

Scope of application

Elevators: Measurement under the cabin floorMeasuring under the floor of the cabin simplifies getting the most accurate results. Measurements can be nulled to within 5kg to allow for reliable detection of the empty cabin state. The large range of the sensors (1000:1) allows very small loads (down to 5kg) as well as heavy loads (up to 10t) to be accurately reported.

FORCE MEASURING SPRING FOR LOADS FROM 630 .. 2500KG, WITH EXCELLENT ZERO-POINT MEASURING CAPABILITY

Measuring spring LMF is clamped at one end and loaded at the other. The resulting deflection is converted into an electrical signal by a strain-gage. The force-measuring spring is particularly suited to measure static loads in the elevator cabin and in the motor room. With suitable accessories, it can also be used to measure the load at the anchor point of the cable.


Features:

• six measuring ranges
• output cable with plug
• suited for use with a LON interface
• junction box X-914-1
• very accurate measurements
• very well suited for measuring the no-load force
• delivered in sets of four